Rated 5 out of 5 by 1oldnavyguy perfect fit, great price, easy install,
was a great experience, thanks david at east charleston pepboys store in las vegas, well done getting part that morning by 1030, i installed it in less than an hour and was out to my next job, I earn my living with my truck, so thanks again.
July 8, 2016
Rated 5 out of 5 by Rjodom5 Great product and easy to install
2010 Honda Crosstour: I had to replace 2 of the original coils so far with only 60k on them. Way easy to install, increased power and gas mileage. Make sure to get your pep boys coupons to save money!
March 25, 2016
Rated 5 out of 5 by yacyac great product
This product saved me from selling my Jeep. After replacing the 1 defective i replaced the remaining 3 and my Jeep now runs better then new. Never thought that this was possible.
November 11, 2015
Rated 2 out of 5 by vampire Part no good
Had to return part because it was defective.
October 7, 2015
Rated 5 out of 5 by Blackdevoid33 Excellent Product
I'm replacing my Nissan Altima original ignition coils to this one, the performance is exactly the same and the lifetime warranty is a mayor plus.
October 2, 2015
Rated 5 out of 5 by CASparky It Works
Needed to replace a bad coil. Put one of these in, and it works. No more miss. With the site-wide discount, this was the least expensive option out there. Can't speak to durability since it's only been a few weeks.
September 27, 2015
Rated 1 out of 5 by Technocrat Coil
Coil had no continuity on primary circuit. Test the product before installation for primary and secondary windings. Do not assume that every unit meets your specification! Ended up purchasing and installing other ignition components which were unnecessary which was costly and delaying in repair. Quality Control is no longer a standard in our import manufacturing process....or maybe just one of few which missed sampling....
August 24, 2015
Rated 5 out of 5 by doglover E51 Ignition coil
I have a 1995 Olds 88 Royale it would not start when it got hot so I bought 3 E51 coils installed them in 30 min or less and put lot of dielectric grease on exposed metal now it starts every time. before it would not start after I went somewhere until it cooled down for a couple hrs.
August 18, 2015