See Details

30% Off Online Orders of Select Parts and Accessories. Enter Promo Code 30PEP in Cart

Close (X)

30% Off Online Orders of Select Parts and Accessories
Receive 30% Off Your Online Purchase. Use promotional code PEP30 at checkout to receive discount. Not valid in combination with any other discounts or promotions. Not valid on gift cards, special orders, installed merchandise, commercial or fleet purchases. Excludes the following categories: Tires, Wheels, Batteries, Powerstop Brake Kits, Oil, Antifreeze, Refrigerant, Truck Boxes, Vent Visors, Bug Shields and BRANDS: Razor, Traxxas, Superchips, Hypertech, Edge, Bully Dog, Diablo, Edelbrock, Holley, NOS, Proform, Specialty Auto, Thule, Autometer, Accel, K&N, Kenwood, Pioneer, Sony, JVC, MSD and BBK Performance. Valid online until 2:59 am EST on 9/29/16. Online orders scheduled for in-store pick up must be completed by closing on 9/28/16 for discount to apply.

Many people have never replaced their own headlight bulbs and are a little intimidated by the job. But for the majority of cars, replacing the bulb of your headlight can be a simple task that takes less than a few minutes and requires no tools.
Here are a few tips and tricks to make sure your headlight replacement runs smoothly:

Make sure you get the right replacement headlight bulb for your specific car. Choose between a direct replacement or upgrade with a wider light span or a brighter bulb.

Be careful to never touch the glass of a halogen headlight bulb. The natural oils from your hands can cause the bulb to burn out prematurely. Use latex gloves or a paper towel to handle the bulb, and if you accidently touch the glass, wipe it down with isopropyl alcohol.

Using a bit of dielectric grease on the base of the bulb will ensure it gets a good electrical contact, and it will help you get the full service life out of the bulb. Dielectric grease is available in one-use packets, perfect for headlight replacement.

Most headlight bulbs can be reached and replaced without tools, but take your time when removing and installing the bulbs. If you’re too rough, you may accidentally pull the wires out of the sockets or clips.

Consult your owner’s manual on where to find your bulbs and how to remove and install them. Some bulbs are held into the headlight assembly by the wiring socket assembly, while other bulbs install directly into the headlight assembly. Most bulbs and socket assemblies are removed (and installed) with either a push-in-and-turn motion or by releasing small clips used to hold the pieces together.

Tip: Don’t remove both clips at the same time. Use one side for reference when replacing the other, and repeat the process for the other side.

Check the aim of your headlights. While driving, headlights can become loosened and knocked out of proper alignment due to rough road conditions. This can cause the light output of your bulbs to be directed away from where you need it most - on the roadway. Pull your vehicle up to a garage door or wall and check to see that both headlights shine at the same angle. If you need to adjust the aim, consult your vehicle’s owner manual.

If you’re having a difficult time finding out how to get to your headlight bulbs, you may have one of the few vehicles that require disassembly of car panels and/or removal of the headlight assembly in order to change the bulb. In general,
how-to-videos for these vehicles can be found on YouTube.

Replacing your vehicle’s headlights will provide you with the best possible on-road lighting to ensure your safety. Whether it’s your ability to see the road and your surroundings or other motorists’ ability to see you, having bright, working headlights is essential for every driver. If you would rather have your headlights replaced for you, visit one of your local Pep Boys today and make an appointment.